For your Netgear WiFi router to work smoothly, it is important that it gets a firmware update every now and then. However, if you aren’t able to update the firmware of your router, then you are in big trouble! But, worry not! Every issue has a solution. This one has too. Go through the troubleshooting tips mentioned below and learn how to get rid of the Netgear router firmware update failure issue in a jiffy.
Reasons Why Netgear Router Firmware Update Failed?
Here are some of the most common reasons why you aren’t able to update the firmware of your Netgear WiFi device:
- Weak or no internet.
- Unstable Ethernet connection.
- Too much distance between your Netgear router and the existing modem.
- Technical glitches.
- WiFi Interference.
Now that you are aware of the reasons why you’re facing the Netgear router firmware update failure issue, follow the Netgear router troubleshooting tips mentioned below to fix it.
Fixed: Netgear Router Firmware Update Failed
- Check Your Internet Connection
As mentioned above, one of the major reasons why you aren’t able to update the firmware of your Netgear router is because of a weak internet connection. Therefore, make sure that your internet connection is strong.
Check the connection between your Netgear router and modem. Is it strong enough? No? Well, that’s probably because you’ve connected them wirelessly. To fix the issue, it is recommended that you connect your devices with the help of an Ethernet cable.
If switching to a different connection source doesn’t fix the issue for you, get in touch with your Internet Service Provider. Chances are that the issue is from his end. If he confirms the same, ask him to get the issue fixed as soon as possible.
- Reboot Your Netgear Router
If you aren’t able to perform Netgear router firmware update via routerlogin due to technical glitches, reboot your device.
In order to reboot your home router, outlined below are the steps you need to follow:
- Disconnect every WiFi-enabled device connect to your router’s network.
- Power off your Netgear WiFi router and unplug it from the wall socket.
- Wait for a couple of seconds.
- Then, plug your Netgear router back into the wall socket and switch it on.
Once you are done rebooting your device, try to perform Netgear router firmware update. Any luck? If not, then sadly, you have no other option than to reset your device.
- Reset Your WiFi Router
Follow the instructions mentioned below to restore your device to the factory default mode:
- Look for the Reset button located at the bottom of your Netgear router.
- Once found, take an oil pin or a toothpick and carefully press the Reset button.
- Now, give your device some time to get restored to the default settings.
Note: Do not forget to perform Netgear router setup after resetting your WiFi device.
As soon as you are done resetting your Netgear WiFi router, try to update its firmware by following the guidelines mentioned below.
Steps to Perform Netgear Router Firmware Update
Here are the steps that’ll help you update the firmware of your Netgear WiFi router to the latest version:
- Plug your Netgear router into a working wall outlet and turn it on.
- Connect your router and the modem with the help of an Ethernet cable.
- Then, switch on your PC and open an internet browser on your PC.
- Access routerlogin.net to access the Netgear router login page.
- Use the default username and password and hit Log In.
- On the BASIC Home screen, head over to the Settings option.
- Select Maintenance and click Firmware Update.
In a minute or two, the firmware of your Netgear router will get updated to the latest version.
By following the aforementioned troubleshooting tips, you’ll surely be able to get rid of the Netgear router firmware update failure issue. If you do, don’t forget to leave a word of appreciation in the comments section below.